Product ID:S-830-RR GREASE
MSDS Date:11/01/1989
FSC:9150
NIIN:01-197-7689
MSDS Number: BGQJQ

BATTENFELD GREASE AND OIL CORP OF NEW YORK INC.

1174 ERIE AVE
NORTH TONAWANDA, NY 14120-3036
US

Emergency Phone: 716-695-2100

Info Phone: 716-695-2100

Preparer: THOMAS G. MUSILLI

Cage: EO110

BATTENFELD GREASE AND OIL CORP OF NEW YORK INC

728 NORTH TONAWANDA, NY 14120-3036 US

Telephone: 716-695-2100

Cage: EO110

LITHIUM 12 HYDROXYSTEARATE

CAS: 7620-77-1

Fraction By Weight: 10.0%

MINERAL OIL

CAS: 64742-65-0

RTECS: PY8038500

Fraction By Weight: 33.0%

SYNTHETIC HYDROCARBON BASE OIL

CAS: 68649-12-7

Fraction By Weight: 50.0%

PHOSPHATE ESTER

CAS: 68025-51-4

Fraction By Weight: 5.0%

ZINC DIAMYLDITHIOCARBAMATE

CAS: 15337-18-5

Fraction By Weight: 2.0%

OSHA PEL 5 MG ZN/M3

ACGIH TLV: 5 MG ZN/M3

LD50 LC50 Mixture:LD50 (ORAL RAT) IS NOT AVAILABLE
Routes of Entry: Inhalation:NO Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:MAY BE MILDLY IRRITATING. RELEASE
DURING HIGH PRESSURE USAGE MAY RESULT IN INJECTION OF OIL INTO THE
SKIN CAUSING LOCAL NECROSIS. HIGH TEMPERATURE VAPORS MAY IRRITATE
RESPIRATORY TRACT. LOW LEVEL OF T OXICITY(INGESTED). CHRONIC
OVEREXPOSUREMAY CAUSE SKIN DISORDERS, DERMATITIS.
Explanation of Carcinogenicity:NONE OF THE COMPOUNDS IN THIS PRODUCT IS
LISTED BY IARC, NTP, OR OSHA AS A CARCINOGEN.
Effects of Overexposure:EYE:POSSIBLE IRRITATION. SKIN:POSSIBLE
IRRITATION, DERMATITIS WITH CHRONIC EXPOSURE. INHALED:UNLIKELY
EXPOSURE. INGESTED:G/I IRRITATION, LOW TOXICITY.
Medical Cond Aggravated by Exposure:PRE-EXISTING SKIN DISORDERS MAY BE
AGGRAVATED BY EXPOSURE TO THIS PRODUCT.

First Aid:EYE: FLUSH WITH WATER FOR 15 MINUTES WHILE HOLDING EYELIDS
OPEN. GET MEDICAL ATTENTION. SKIN: WASH WITH SOAP & WATER/WATERLESS
CLEANER. REMOVE CONTAMINATED CLOTHING AND LAUNDER BEFORE REUSE. IF
IRRITA TION PERSISTS SEE A DOCTOR. INHALED:REMOVE TO FRESH AIR.
GIVE OXYGEN IF BREATHING IS DIFFICULT AND GET MEDICAL CARE.
INGESTION: DO NOT INDUCE VOMITING. IN GENERAL, NO TREATMENT
REQUIRED. SEE DOCTOR.

Flash Point Method:COC
Flash Point:370F,188C
Autoignition Temp:Autoignition Temp Text:400F
Extinguishing Media:USE CARBON DIOXIDE, FOAM, DRY CHEMICAL, WATER FOG,
EARTH OR SAND.
Fire Fighting Procedures:FIRE FIGHTERS SHOULD USE NIOSH APPROVED SCBA &
FULL PROTECTIVE EQUIPMENT WHEN FIGHTING CHEMICAL FIRE. USE WATER
SPRAY TO COOL NEARBY CONTAINERS EXPOSED TO FIRE.
Unusual Fire/Explosion Hazard:WATER USED FOR EXTINGUISHING MEDIA MAY
CAUSE THE GREASE TO FROTH.

Spill Release Procedures:SCOOP UP EXCESS GREASE. CLEAN AREA WITH
APPROPRIATE CLEANER.
Neutralizing Agent:NONE.

Handling and Storage Precautions:STORE IN A COOL, DRY PLACE WITH
ADEQUATE VENTILATION. KEEP CONTAINERS TIGHTLY CLOSED WHEN NOT IN
USE. KEEP AWAY FROM OPEN FLAMES & HIGH TEMPERATURES.
Other Precautions:NONE

Respiratory Protection:RESPIRATORY PROTECTION WILL NOT NORMALLY BE
REQUIRED. IF VENTILATION DOES NOT MAINTAIN INHALATION EXPOSURES
BELOW PEL(TLV), USE NIOSH/MSHA APPROVED RESPIRATORS AS PER CURRENT
29 CFR 1910.134, INSTRUCT IONS/WARNINGS.
Ventilation:NORMAL ROOM VENTILATION IS NORMALLY SUFFICIENT.
Protective Gloves:BUTYL OR NEOPRENE RUBBER AS REQUIRED.
Eye Protection:SAFETY GLASSES, OR FACE SHIELD RECOMMEND
Other Protective Equipment:EYE WASH STATION AND SAFETY SHOWER.
INDUSTRIAL-TYPE WORK CLOTHING AND APRON AS REQUIRED BY TASK AT
HAND.
Work Hygienic Practices:OBSERVE GOOD PERSONAL HYGIENE PRACTICES AND
RECOMMENDED PROCEDURES.
Supplemental Safety and Health
MFR HAS 2 FORMULATIONS ON THE QPL. SEE P/N IND B FOR MSDS OF OTHER
FORMULATION.

HCC:V6
Boiling Pt:B.P. Text:650F,343C
Melt/Freeze Pt:M.P/F.P Text:350F,177C
Spec Gravity:0.88
pH:UNKNON
Solubility in Water:NEGLIGIBLE
Appearance and Odor:AMBER BUTTERY GREASE, BLAND ODOR
Percent Volatiles by Volume:0

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:NONE GIVEN BY MANUMACTURER.
Hazardous Decomposition Products:COMBUSTION WILL PRODUCE A MIXTURE OF
AIRBORNE SOLID, LIQUID PARTICULATES AND GASES (CARBON MONOXIDE &
CARBON DIOXIDE).

Waste Disposal Methods:DISPOSE I/A/W ALL FEDERAL, STATE AND LOCAL
REGULATIONS. MANUFACTURER SUGGESTS THAT DISPOSAL MAY BE DONE BY
INCINERATION.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.